2026-10-12T22:41:42Z https://www.scidb.cn/oai

10.57760/sciencedb.03529 2022-11-02T17:35:18Z

2022-11-02 Modeling very high electron heating by radio frequency waves on EAST doi:10.57760/sciencedb.03529 en In the 2018 EAST experimental campaign, a very high central electron heating, fully-non-inductive discharge with the core electron temperature over 9 keV has beenachieved. Such high central electron heating was realized by injecting radio frequency waves, including 1.8 MW lower hybrid wave (LHW) and 0.8 MW electron–cyclotron waves (ECW).Experimental diagnosis indicates two different time scales characterizing the electron heating process, a rapid and a slow rise of the central electron temperature after the injection of ECW.In this work, integrated modeling is performed to investigate the physical mechanisms of such high electron heating. Five characteristic phases during the increase of the electrontemperature are chosen for modeling. In phase 1, the electron heating is by LHW alone. The modeling confrms that the LHW can only sustain the core electron temperature Te ≈ 5.5 keV,which is consistent with the experiment. In phase 2, the electron temperature increases rapidly after the frst 0.4 MW ECW is injected. The result shows that the rapid increase of the electrontemperature is due to the interaction between the ECW and the electrons. With the increase of the electron temperature, the electron flux induced by the trapped electron modes (TEMs) andthe electron temperature gradient driven modes (ETGs) is enhanced in the core region. In phase 3, the electron temperature increases slowly after phase 2. It is found that the slowincrease is mainly due to the flattening of the density profle. The flattening of the density profle can decrease the thermal diffusivity of the electrons mainly induced by the TEMsleading to a higher electron temperature for a given heating source. In phase 4, the electron temperature again increases rapidly after the second 0.4 MW ECW is injected. The physicalmechanism is similar to that in phase 2. In phase 5, the LHW power deposition of the LHW remains almost unchanged compared to that in phase 4 since the electron temperature issuffciently high. The slow rise of the electron temperature is caused by the improvement of the electron energy confnement as thermal diffusivity of the electrons is decreased due to theflattening of the electron density profle, which is similar to the main reason in phase 3. radio frequency waves ; electron heating; integrated modeling Yueheng Huang Nong Xiang Jiale Chen PUBLIC https://creativecommons.org/licenses/by/4.0/ dataset http://www.doi.org/10.1088/1741-4326/ac1199 Science Data Bank